Switch unit for shutters
RFJA-12B

DESCRIPTION

• The switching unit for blinds has 2 output channels used to control garage doors, gates, blinds, awnings, etc.
• It can be combined with Control or System units iNELS RF Control.
• The BOX design lets you mount it right in an installation box, a ceiling or motor drive cover.
• RFJA-12B/230V (120V): connection of switched load 2x 8 A (2x 2 000 W).
• RFJA-12B/24VDC: contactless quiet switching.
• RFJA-32B/230V (120V): connection of switched load 2x 8 A (2x 2 000 W), with the ability to connect existing buttons.
• RFJA-32B/24VDC: contactless quiet switching with the ability to connect existing buttons.
• Short presses of the controller enable tilting of lamellas, and a long press enables you to draw the blinds up or down to the end position.
•  Each of the units may be controlled by up to 25 channels (1 channel represents one assigned controller).
• The programming button on the unit is also used for manual control of the output.
• For components it is possible to set the repeater function via the RFAF / USB service device.
• Range up to 100 m (in open space), if the signal is insuffi cient between the controller and unit, use the signal repeater RFRP-20 or protocol component RFIO2 that support this feature. 
• Communication frequency with bidirectional protocol iNELS RF Control2 (RFIO2 ).

TECHNICAL PARAMETERS

• Supply voltage: 230 V AC / 120 V AC / 50 - 60 Hz
• Number of contacts: 2 x 8 A switching (AgSnO2)
• Range in free space: up to 100 m
• Mounting: free at lead-in wires
• Protection: IP30
• Dimensions: 49 x 49 x 21 mm
• Weight: 46 g

Downloads

• Datasheet RFJA

  Format: pdf | Size : 142 kB | 05. 03. 2021

• EC Declaration of conformity RFJA-12B 230V

  Format: pdf | Size : 47 kB | 27. 10. 2017